Large Display Temperature Meters
Instruction Manual
15
SETUP AND PROGRAMMING
Overview
To setup and program the Digital Temperature Meter, it is necessary to
disassemble the Display PCB. See disassembling instructions in the next pages.
Setting up and programming the Digital Temperature Meter involves four basic
steps:
1. Jumper Configuration (Page 19)
a. Input
selection
and lockout jumpers
b. Relay acknowledge enable
c. Fail-safe operation of relays
2. Power Selection (Page 20)
a. Changing to 230 VAC power if needed. 115 VAC is factory default on
AC powered models.
b. Labeling meter for power input: 115 VAC or 230 VAC (24 VDC powered
models are labeled as such at the factory).
3. Connections (Page 21)
a. Power
connections
b. Signal
connections
c. Enter, acknowledgement, and hold reading
d. Relays
connections
e. 4-20 mA output connections
4. Programming (Page 29)
a. Basic
meter
b. Alarm setup and set points
c. 4-20 mA output
d. Lockout
jumper
Programmed Parameter Settings
To simplify programming, write down the desired programming values prior to
attempting to program the meter. The
Programmed Parameter Settings
form,
located on page 69, provides a convenient method to record the user settings; it
also provides the factory setting for most of the programmable parameters.
