Large Display Temperature Meters
Instruction Manual
18
Reassembling the Meter
After the wiring and jumper selections have been made, reassemble the Display
PCB.
Reassembling the PD755
1. Place the Display PCB on top of the four standoffs. Make sure the ribbon
cable is connected to the connector on the Display PCB.
2. Replace the four mounting screws (see Figure 28 on page 60).
3. Install enclosure’s cover matching enclosure base and cover tabs.
4. Fasten the four screws that hold the enclosure cover in place.
Reassembling the PD756
1. Slide the Display PCB under the two screws on the right side of the Display.
PCB (see Figure 29 on page 60).
2. Replace the two mounting screws on the left side of the Display PCB.
3. Tighten the two mounting screws on the right side of the Display PCB
4. To program the meter using the front panel buttons leave cover off until
meter programming is complete.
5. Replace the enclosure cover.
Reassembling the PD757
1. Slide the Display PCB under the top three screws (see Figure 30, page 61).
2. Replace the bottom three mounting screws.
3. Tighten the top three mounting screws.
4. Align the enclosure cover so the alarm numbers on the cover are on the left
side of the meter and aligned with the alarm status LEDs.
5. To program the meter using the front panel buttons leave top cover off until
meter programming is complete.
6. Replace the enclosure cover and tighten the four screws that hold it in place.
