PD6701 Field-Mount Loop-Powered Feet & Inches Level Meter
Instruction Manual
20
Operation
Front Panel Buttons Operation
Button Symbol
Description
Press to Enter or Exit
Programming Mode
Used to Reset Maximum and
Minimum Values
Press to Cycle Displaying
Maximum Value, Minimum
Value, and Input Current in mA
Press to Resume Run Mode in
Lower Display
Press to Acknowledge Alarm
(if Enabled)
Display Maximum, Minimum,
and Input Current
The maximum and minimum values and the
measured input loop current may be displayed
temporarily on the lower display. To display these
values, press the
DISPLAY
button. The meter will
display the word
MAXIMUM
on the lower display and
the maximum value reached (since the last maximum
reset) on the upper display. Press the
DISPLAY
button again and the meter will display the word
MINIMUM
on the lower display and the minimum value
reached on the upper display. Pressing the
RESET
button while either of these values is displayed will
reset that value to the current display value.
Press the
DISPLAY
button a third time and the meter
will display
LOOP
MA
on the lower display, followed by
the measured input current in milliamps (mA). The
current display will remain for 10 seconds and then
the lower display will return to normal run mode as
programmed in
DISPLAY
button a
fourth time to return to the normal operation. The
meter will display
RESUME
followed by the run mode
lower display.
Reset Meter to Factory Defaults
When the parameters have been changed in a way
that is difficult to determine what’s happening, it might
be better to start the setup process from the factory
defaults.
Instructions to load factory defaults:
Enter the
Advanced
features menu.
Press and hold
RESET
button when
INFO
is shown.
For information on navigating to the
Information
menu, refer to
Press
ENTER
when
DFALTS?
prompt is flashing.
Note: If
ENTER
is not pressed within three seconds,
the prompt will stop flashing return to run mode.
MENU
RESET
FT
IN
FT
IN
FT
IN
FT
IN
FT
IN
FT
IN
DISPLAY
ENTER
