Precisa 360 ES Series, Operating Instructions Manual

Page: 21 / 77

10 Operation ■
19
En
gl
is
h
For calibration of the balance see chapter 9.7 "Calibration of the balance" and see chapter 22.1 "Calibra-
tion". The setting depends on the balance model.
10.3.5
Weighing mode
With the aid of the Weighing mode functions, you may define the quality of the balance location (see chapter
9.4 "Choosing a suitable location").
With the aid of the „AUTO-STANDBY“ function, you can define the period of non-use before the balance au-
tomatically switches into the energy-saving mode.
„FLOATINGDISPLAY“
The value set for „FLOATINGDISPLAY“ defines the period after which each new measurement is displayed.
For the definition of this period, the quality of the balance location is crucial. The stability control must also
set appropriately.
Recommended values:
– Optimum balance location: „FLOATINGDISPLAY 0.08“
– Good balance location: „FLOATINGDISPLAY 0.16“
– Critical balance location: „FLOATINGDISPLAY 0.32“
„STABILITY“
The value set for the stability control depends on the quality of the balance location and must be correctly
chosen in order to obtain optimum, reproducible results. Choose:
– Optimum balance location: „STABILITY LOW“
– Good balance location: „STABILITY MEDIUM“
– Critical balance location: „STABILITY HIGH“
DEF. 0.000 g Calibration weight for EXT.-DEF. mode
AUTOCAL. TIME/TEMP.
TEMPERATURE
TIME
Auto-calibration on time and temperature
Auto-calibration on temperature
Auto-calibration on time
AUTOCAL.-TIME 6 h Time for auto-calibration
• SET WEIGH-
ING MODE
FLOATINGDISPLAY 0.08
0.16
0.32
Input integration time (in seconds)
STABILITY LOW
MEDIUM
HIGH
Setting the stability control (instability of the bal-
ance location)
AUTO-STANDBY OFF
0.5 MIN.
1 MIN.
5 MIN.
10 MIN.
Auto-Standby not active or active after nn minutes
AUTO-ZERO ON /OFF Automatic zero correction on/off
QUICK-TARE ON/ OFF Quick-Tare on/off
ZERO-RANGE 0.000 g Maximum weight where a zero function in perfor-
med
NOTE
The Auto-Standby function only works with the automatic zero-correction activated („AUTO-ZERO“).
NOTE
The value of the Floating Display is a function of the stability control and the balance location. For balance
location, see chapter 9.4 "Choosing a suitable location" and see chapter 10.3.5 "Weighing mode".