6
ASSEMBLY
PREREQUISITES
The wallbox may only be installed by a trained electrician.
Before installation the device must be thoroughly checked for
damage. The wallbox is only suitable for vertical installation.
The wallbox may be installed indoor or in protected outdoor areas, such as under canopies.
The ambient temperature at the installation site must be in the range of -20°C to +40°C.
The wallbox must be mounted away from easily flammable parts.
Sufficient ventilation must be ensured during operation.
The installation location must be chosen so that the connected charging cables cannot come into contact with water.
To prevent the ingress of water check the proper fit of the cover and the tight fit of the cable glands after installation.
WALL MOUNTING
1.
The enclosed mounting plates (left/right) must be mounted on the back of the wallbox using four self-tapping screws
each. Make sure that the bevelled tabs are oriented towards the centre of the housing (see figure 1).
2.
Use the enclosed drilling template to transfer the drilling distances for wall mounting to the wall.
3.
Drill holes in the wall.
4.
Insert four dowels (not included in the scope of delivery) according to the wall condition.
5.
Screw the two lower screws into the dowels and place the wallbox on the screws using the screw holes.
6.
Screw the upper screws into the wall plugs, align the wallbox and finally fasten it using the four screws.
Tabs
Figure 1 Arrangement of the mounting plates
The next step is the electrical connection of the wallbox.
