7/24
SETUP OPTIONS-PROJECTOR CONFIGURATION
A device configuration can be set conveniently via press button switch and LCD display.
Launch the projector. Press button ENTER more than 5 seconds to unlock panel, LCD display shows functional menus which have
their own sub-menus for designated functions, the below is the details
Press button UP or DOWN if you want to browse through the various Setup Options.
Press button ENTER to save your settings or enter the next menu.
Press button UP or DOWN to shift.
Press button FUNC, it will return to the upper menu one by one. If you stay for minutes defaulted will show display status
automatically.
TO SET THE DMX START ADDRESS
Each projector must be given a DMX start address so that the correct projector responds to the correct control signals. This DMX start
address is the channel number from which the projector starts to “listen” to the digital control information being sent out from the
controller. The fixture have 3 DMX modes. There are standard mode, extended mode and short mode. For example standard mode
has 19 channels, so set the No. 1 projector’s address 001, No. 2 projector’s address 020, No. 3 projector’s address 039, No. 4
projector’s address 058, and so on.
Launch the projector. Press button ENTER more than 5 seconds to unlock panel.
Press button FUNC to display
DMX address
;
Press button UP and DOWN, you can set the address;
Press button ENTER to confirm, after powered next time, the last saved settings will be showed.
Press button FUNC, it will return to the upper menu one by one.
STAND-ALONE MODE
Operate the projector without connecting a controller, enable the master mode in the operation panel, the projector
will run in Stand-Alone mode automatically.
DMX address can be set without limitations.
MASTER/SLAVE MODE
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. Select one
projector as the master with setting options at any mode of master’s modes enabled and make the other projectors as
the slaves with setting options slave mode enabled and their DMX start address “001”.
Using XLR-XLR cables, Connect the first fixture’s output to the second fixture’s input, and connect the second fixture’s output to the
third fixture’s input and connect the rest fixtures in the same way. Eventually connect the last fixture’s output to a DMX terminator as
shown in the figure below.
After powered, the group will run in synchronous Master/Slave Mode.
W-DMX
DMX
PR-8163
XRLED 700 Spot
