16/24
Linear Zooming
CH13 Pan
0-255
0°~540°Forward Rotation
CH14 Tilt
0-255
0°~270°
CH15 Pan & Tilt Speed
0-255
Speed from fast to slow
CH16 Pan & tilt Time mode
0-25 Second
Remark:
1.
In the synchronous control of multiple projectors parameters can be transmitted from the master including: DMX mode,
display setting, operation mode(user memory data included);
2.
All projectors Accepting parameters will automatically be set to slave mode.
Explanations for the logos on top-right of the display
S: Slave M: Master
D: DMX 512 I: Preset Memory
U: User’s Memory T: Test Mode
Lock Logo: all buttons are locked, press “ENTER” button for more than 5 seconds till lock logo disappears and buttons are
unlocked.
REPLACING GOBOS
Disconnect the fixture from power. Carefully lift off the cover by undoing the 4 fast-fit screws.
Before the replacement of fixed gobos, take leaf spring out using finger, push the gobos out carefully and insert new gobos.
For rotating gobos: take rotating gobo wheel out by hand, push gobos out after pulling out leaf springs. Insert new gobos into gobo
holders, then insert leaf spring back and make sure it is in narrow ring groove in the holder, i.e. internal ring groove in the holder, then
flatten it. At last, use appropriate tool to push tightening spring back, then put the holder back into the wheel by another hand.
Note:
If the gobo is a glass one, it should be touched with glabrous, clean and soft tissue or cloth matted between hand and glass
instead of with bare hand. Close the rear cover and fasten 4 fast-fit screws.
Rotating Gobo Wheel
Fixed Gobo Wheel
