19/24
192-255
Forward rotation from slow to fast
11
12
14
Focus
000-255
Linearly focusing
15
Focus Fine
000-255
Focus in 16 precision
12
13
16
Zoom
000-255
Linearly focusing
17
Zoom Fine
000-255
Focus in 16 precision
13
14
18
Pan
000-255
Forward rotation 0°~ 540°
15
19
Pan Fine
000-255
Pan rotation in 16 precision
14
16
20
Tilt
000-255
Tilt rotation 0°~270°
17
21
Tilt Fine
000-255
Tilt rotation in 16 precision
18
22
Pan & Tilt
speed
000-255
Pan &Tilt speed from fast to slow
15
19
23
Control
000-048
Reserved
049-255
Reset
Note:
****While prior Channel is used, lower channel is invalid
INDICATION OF LCD Display
Green LED indication
On
DMX signal OK
Off
No DMX signal
Blue LED indication
On
Linked with Wireless Transmitter
Off
Not linked with transmitter
Flash
Being linked with a transmitter or losing link
MAINTENANCE
If the projector does not function, check the fuses on the power socket of the projector, they should only be replaced by fuses of the
same specification. Should these be damaged call a qualified technician before replacement. The projector has thermal protection
device that will switch off the projector in case of overheating, should either of these operate, check that the fans are not blocked, and if
they are dirty clean them before switching on the projector again. Check that the fans are operational, if not call a qualified technician.
Any maintenance work should only be carried out by qualified technicians.
LUBRICATION
To ensure the continuous rotation of the rotating gobos and linear motion of the lens for focusing, it is recommended that the bearings
for the rotating gobos and the 2 shafts for the focusing lens holder be lubricated periodically, preferably every two months. Use only
high quality, high-temperature resistant grease instead of any type of oil. When lubricating
the bearings, a syringe with a fine needle is the easiest way to introduce the grease to the bearings around each gobo.
KEEPING THE PROJECTOR CLEAN
To ensure the reliability of the projector it should be kept clean. It is recommended that the fans should be cleaned every 15 days. The
lens and dichroic colour filters should also be regularly cleaned to maintain an optimum light output.
Do NOT use any type of
solvent on dichroic colour filters.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoke or particularly dirty surroundings can
cause greater accumulation of dirt on the unit’s optics. A soft cloth and typical glass cleaning products should be used in cleaning. It is
recommended to clean the external optics at least once every 20 days and clean the internal optics at least once every 30 / 60 days.
