PowerSource 10000, User Manual

Page: 3 / 52

2
1. Safety Instructions and Battery Care
1.1. Safety Instructions
1.1.1. For Parallel System installation please refer to MSII 6KVA Parallel System
Installation Guide
1.1.2. Because of small leakage currents generated by the EMI filter in the UPS
it is necessary to double check that the ground wire of the UPS is
properly grounded before connecting the UPS to the AC mains.
1.1.3. To ensure safety in all applications where a UPS is hard wired to the
electrical supply, ensure that the system is installed by a qualified
electrical contractor.
1.1.4. The UPS has its own internal energy source (battery). Should the battery
be switched on when no AC power is available there could be voltage at
the output terminals.
1.1.5. Make sure that the AC utility outlet is correctly grounded.
1.1.6. Do not open the case as there are no serviceable parts inside. Opening
the case voids the warranty.
1.1.7. Do not try to repair the unit yourself; contact your local supplier. Repairing
the unit yourself voids the warranty.
1.1.8. Please make sure that the input voltage of the UPS matches the supply
voltage.
1.1.9. Use a certified input power cable with the correct plugs and sockets for
the appropriate system voltage.
1.1.10. To prevent any overheating of the UPS keep all ventilation openings free
from obstruction, and do not store things on top of the UPS. Keep the
UPS 30 cm away from the wall.
1.1.11. Ensure that the UPS is installed within the proper environmental range.
(0-40

C and 0-90% non-condensing humidity)
1.1.12. Do not install the UPS in direct sunlight. Your warranty may be void if the
batteries fail.
1.1.13. Install the UPS indoors as it is not designed for installation outdoors.