PowerSource 10000, User Manual

Page: 25 / 52

24
F
“220 VAC” in Utility Input
3.5.1.8. If the self-test fails the LCD display will change from figure D to
figure E2. Then an error code or error status will appear on the
screen.
3.5.1.9. Your start-up operation of the UPS is complete now. Make sure
the UPS is plugged into the wall receptacle for charging at least 8
hours and the batteries are fully charged before connecting the
device to be protected.
3.5.2. Start-up in Battery Mode (Cold Start)
3.5.2.1. Make sure the UPS has at least one set (20 pcs) of 12V/7AH
batteries.
3.5.2.2. Push the UPS On Switch once for approximately 5 seconds
to awaken the UPS. The buzzer will sound twice. The LCD
display will change from figure A to figure G for approximately 15
seconds.
3.5.2.3. Press the UPS On Switch again for about three seconds
until the LCD display changes from figure G to figure H. Then the
UPS will be in self-test mode. The UPS may offer energy to the
output in a minute, and the LCD displays figure I. In case of
failure in pushing the UPS On Switch for 15 seconds, the UPS
will automatically turn off. You must then repeat steps 3.5.2.1 to
3.5.2.3.
3.5.2.4.
G
“Off”, which means the UPS pre-start was successful