powersoft M-Drive IK, User Manual

Page: 23 / 55

13
LED chart
13 : 1.Interface board LED chart
For a comprehensive control on system status refer
to the ArmoníaPlus metering interface (ref. Chapter 15 : 5.
Metering ).
Color Label Signal Lighting
RED PROTECT
Signal protection
active
SOLID ON
No pressure sensor
connected
BLINKING
RED LIMIT Limiter active SOLID ON
GREEN SIGNAL Input signal present SOLID ON
GREEN E.SAVE
Energy save mode
active
SOLID ON
YELLOW TEMP
Thermal protection
active
SOLID ON
GREEN READY
No faults, system
fully operating
SOLID ON
GREEN ON System on SOLID ON
13 : 2.SIMM board LED chart
Color Code Signal Lighting
GREEN D2 +5V
DC
SOLID ON
RED D4 signal clip ON
GREEN D5 ready SOLID ON
RED D8 protection active ON
The architecture of Powersoft’s amplifiers encompass
several protection mechanisms triggered by harmful signal
and temperature. Protection systems and triggers are
independently implemented in the power supply section
(power supply protection) and the amplifier section (amplifier
protections). (ref.
Chapter 15 : 3.Advanced parameters ).
12 : 1.Thermal Protections and Fan Control
Fan starts to run as soon as the amp module measures
a temperature greater than 35°*, the fan control keeps fan
at maximum speed for the first 2s, then its speed will be
controlled according to operating temperature.
When the amp module reaches 45°**, or when the
module reaches the 500 W threshold, the fan starts to run
at maximum speed.
At 60
o
the temperature Led will turn solid on, at 80
o
the
unit will shutdown.
The temperature of the Amplifier section is monitored
and replicated on the 34 poles interface connector
according to the TEMPON table:
12
FIGURE 12: M-Drive interface plate.
13 | M-Drive | User guide
D2 D8 D5
D4