
15.
Check Gun and Nozzle Extension
Examine the hose connection to the spray gun and
make sure it is secure. Test the trigger by pressing
it and making sure it springs back into place when
you release it. Put the safety latch in the on position
and test the trigger. You should not be able to press
the trigger.
To correct the problem, immediately clean the spray
tips using the tools included with your pressure
washer and follow these instructions:
1. Shut off engine and turn off water supply.
2. Remove spray tip from end of nozzle extension.
Use wire included in kit (or a small paper clip) to
free any foreign material clogging or restricting
spray tip (Fig. 9).
5. Using a garden hose, remove additional debris
by back flushing water through nozzle extension
(Fig.10). Back flush between 30 to 60 seconds.
Purge Pump of Air and Contaminants
To remove air from the pump, follow these steps:
1. Set up pressure washer as described earlier in this
booklet. Connect water supply and turn water on.
2. Pull trigger on spray gun and hold.
3. When water supply is steady and constant, engage
safety latch.
To remove contaminants from the pump, follow
these steps:
1. Set up pressure washer as described earlier in this
booklet. Connect water supply and turn water on.
2. Start engine according to instructions in earlier in
this booklet.
3. Remove nozzle extension from spray gun.
4. Squeeze trigger on spray gun and hold.
5. When water supply is steady and constant, engage
safety latch and reattach nozzle extension.
6. Reinstall spray tip into nozzle extension.
7. Reconnect nozzle extension to spray gun.
8. Reconnect water supply, turn on water and start
engine.
9. Test pressure washer by operating with each
Quick Connect spray tip.
10.
Cleaning Detergent Siphoning Tube
If you used the detergent siphoning tube, you must
flush it with clean water before stopping the engine.
1. Place chemical injection siphon/filter in a bucket
full of clean water.
2. Attach black low pressure spray tip.
4. Shut off engine.
O-Ring Maintenance
Through the normal operation of your pressure
washer,
become worn or damaged.
9.
Use wire here to
remove debris
Nozzle Maintenance
A pulsing sensation felt while squeezing the spray gun
trigger may be caused by excessive pump pressure.
The principal cause of excessive pump pressure is a
spray tip clogged or restricted with foreign materials,
such as dirt, etc.
PS3611ES
Summary of Contents for PS3611ES
Page 11: ...STOPPING THE MACHINE NOZZLE INSTALLATION SELECTION 4 11 PS3611ES...
Page 22: ...22 PS3611ES...
Page 23: ...23 PS3611ES...