www.powershield.com.au
8
The Commander series are equipped with intelligent slot perfect for either SNMP or AS400 card.
When installing either SNMP or AS400 card in the UPS, it will provide advanced communication
and monitoring options.
Step 4: EPO ( Emergency Power OFF ) function
This UPS is equipped with EPO function. By default, the UPS is delivered from factory with Pin 1
and pin 2 closed (a metal plate is connected to Pin 1 and Pin2) for UPS normal operation. To
activate EPO function, remove two screws on EPO port and green connector will be removed.
Note:
The EPO function logic can be set up via LCD setting. Please refer to program 8 in UPS
setting for the details.
Step 5: Turn on the UPS
Press the ON/Mute button on the front panel for two seconds to power on the UPS.
Note:
The battery charges fully during the first five hours of normal operation. Do not
expect full battery run capability during this initial charge period.
Step 6: Install software
Install NetGuard UPS monitoring software to fully configure UPS shutdown. Please follow steps
below to download and install monitoring software:
1. Go to the website
http://www.powershield.com.au/downloads
2. Click NetGuard software icon and then choose your required OS to download the software.
3. Follow the on-screen instructions to install the software.
4. When your computer restarts, the monitoring software will appear as an orange plug icon
located in the system tray, near the clock.
It’s in closed status for UPS
normal operation as default.
To activate EPO
function, remove
these two screws.
