PowerPeak FHT6704, Manual

Page: 48 / 80

Step 2: assembling support tube & the front plastic cover
A: Insert the support tube (10) to the front plastic cover (9) and
then connects the sensor A1&A2 and tension control wire as
shown in FIG.2,
B: Install the support tube (10) on the main frame with arc washer
(3) and bolt (7).
C: Lock the balance bolts on the main frame then put down the
front plastic cover (9).
Attention: Tighten the bolt (7) and the arc washer (3) after the
STEP 3
Step 3: assembling the handlebar
B.
Put the handlebar (13) on the bind cap (18) of the
supporting tube and adjust the comfortable angle,
then install the bind cap (18).
C. Insert the knob (19) on the spring washer (8) and
then put the handlebar (13) on the main frame.