Powermatic 2800, Operating Instructions And Parts Manual

Page: 11 / 28

11
Grounding Instructions
Electrical connections must
be made by a qualified electrician in
compliance with all relevant codes. This
machine must be properly grounded to help
prevent electrical shock and possible fatal
injury.
In the event of a malfunction or breakdown,
grounding provides a path of least resistance for
electric current to reduce the risk of electric
shock. This machine is equipped with an electric
cord having an equipment-grounding conductor
and a grounding plug. The plug must be plugged
into a matching outlet that is properly installed
and grounded in accordance with all local codes
and ordinances. Do not modify the plug provided
– if it will not fit the outlet, have the proper outlet
installed by a qualified electrician.
Improper connection of the equipment-
grounding conductor can result in a risk of
electric shock. The conductor with insulation
having an outer surface that is green with or
without yellow stripes is the equipment-
grounding connector.
If repair or replacement of the electric cord or
plug is necessary, do not connect the
equipment-grounding conductor to a live
terminal.
Check with a qualified electrician or service
personnel if the grounding instructions are not
completely understood, or if in doubt as to
whether the tool is properly grounded.
Use only 3-wire extension cords that have 3-
prong grounding plugs and 3-pole receptacles
that accept the machine’s plug.
It is recommended that the PM2800 Drill Press
be connected to a grounded, minimum 20 amp
circuit with a minimum 20 amp circuit breaker or
time delay fuse. Local codes take precedence
over recommendations.
Repair or replace damaged or worn cord
immediately.
115 Volt Operation
As received from the factory, your drill press is
ready to operate at 115-volt operation. This drill
press, when wired for 115 volt, is intended for
use on a circuit that has an outlet that looks like
the one illustrated in Figure 12. The tool has a
grounding plug that looks like the plug illustrated
in Figure 12.
Figure 12