13
OPERATOR INSTALLATION
1. Mount operator on posts with mounting angles and mounting plates. Secure position
with 2” U-bolts and hardware provided. See Figure 5.
2. Set control arm on output shaft of operator without drive key, and install control arm
extension using hand knobs to secure position. See Figure 6.
3. Install end fittings
on connecting rod
assembly and attach one
end of assembly to end
of control arm extension.
See Figure 7.
4. Install gate bracket on
remaining end of connecting
rod (See Figures 7 & 8)
5. Locate gate bracket in position
on gate, as shown in Figure 8
and clamp in position.
6. Move control arm to its
maximum close position.
See Figure 8. Control arm
and connecting rod must be
straight in line.
FIGURE 7
FIGURE 8
NOTE: TO DISCONNECT OPERATOR FOR
MANUAL OPERATION, REMOVE
HANDKNOBS AND SEPARATE CONTROL
ARM EXTENSION FROM CONTROL ARM.
HAND KNOBS FOR MANUAL DISCONNECT
(USE HOLES SHOWN AS STARTING
POSITION FOR INITIAL SETUP)
CONTROL ARM
EXTENSION
CONTROL ARM
MOUNTING PLATE
MOUNTING ANGLE
OPERATOR
1/4” DRIVE KEY
3/8” BOLT
3/8” LOCK WASHER
3/8” WASHER
DRIVE SHAFT
FIGURE 6
GATE HINGE
36”
OPERATOR
CONTROL ARM
CONNECTING ROD ASSEMBLY
CONTROL ARM
PIVOT BOLT
GATE BRACKET
PIVOT BOLT
GATE
BRACKET
OF GATE
CL
GATE ANGLE
(BY OTHERS)
ELECTRICAL
ACCESS
SET SCREWS
3/8” PIVOT BOLT
3/8” PIVOT BOLT
3/8” HEX NUT
TUBE
SPACER
3/8” HEX NUT
FLAT WASHER
FLAT WASHER
LOCK WASHER
LOCK WASHER
SET SCREWS
ROLL
PIN (4)
SPLICE BAR
CONNECTING
ROD (2PCS)
SPACER BUSHING
END FITTING
FLAT WASHER
FLAT WASHER
FLAT WASHER
SPACER BUSHING
END FITTING
GATE BRACKET
GATE ARM
Summary of Contents for rsw
Page 26: ...Notes...