Powerline BSG10X, Owner'S Manual

Page: 6 / 56

6
1
S t e p
Be careful to assemble all components
in the sequence they are presented.
nOte:
finger tighten all hardware in this step.
• Be careful to not remove the shipping straps holding the lower
frame against the main upright.
A. Stand the gym upright being careful to prevent the gym from falling over
until Rear Leg (B) is attached.
B. Attach Rear Leg (B) to Main Frame (A) as shown using:
Two 75 (3/8” x 3” hex head bolt)*
One 74 (3/8” x 2 3/4” hex head bolt)*
Six 56 (3/8” washer)
Three 63 (3/8” nylon lock nut)
*Note:
The two longer bolts (75) go into the bottom positions and the shorter
bolt (74) on the top position. Use washers (56) on both the bolt and
nut (63) side.
C. Move gym to area of use making sure the main upright is vertical and
then fully tighten the lower leg bolts.
© Best Company srl