PH4000Ri/E Owner’s Manual
27
6.14. Low oil alarm system
The low oil alarm system is designed to prevent engine damage caused by an insufficient amount of oil in the crankcase.
Before the oil level in the crankcase falls below a safe limit, the low oil alarm system will automatically shut down the
engine (the ignition switch will remain in the “ON” position).
If the low oil sensor shuts down the engine, the low oil light (red) will come on when you operate the starter, and the
engine will not run. If this occurs, add enough of the approved engine oil to raise the level to the top line on the dipstick.
•
If the Low Oil light blinks steadily, the ECU has fault codes to report. Refer to the
Fault codes
section
of this manual for more information.
6.15. Stopping the engine
To stop the engine in an emergency
1.
Push the STOP button on the control panel. This will stop the unit with or without the ignition key or remote.
Normal shutdown
1.
Turn off the connected equipment.
2.
If the remote control switch is “OFF”, turn the ignition switch to the “OFF” position.
3.
If the remote control switch is “ON”, push and hold the stop button on the remote or the stop button on the panel
until the engine stops.
•
Always place the remote switch on the control panel in the “OFF” position when not in use for an
extended period of time, to prevent running down the battery. The remote indicator light will illuminate
and flash if the remote switch is on while the generator is not running.
NOTE
!
Low Oil indicator (red)
IIIII
FUEL
U: 000.0 V
P: 0000 W
T: 000.0 H
I: 00.0 A
CAUTION
!
Stop Button
Stop Button (Red)
Ignition
