V 4.0
High Speed Air Body Saw
8633695
OPERATION
1. Draw a guide line for cutting (if possible)
on the workpiece.
2. Press the safety latch on the throttle
lever (13) forward while pressing the
throttle lever (13) to begin operating
the body saw.
NOTE: Allow the saw to reach full
speed before placing the blade onto
the workpiece.
3. Cut your line. Let the body saw do the work. Do not place unnecessary
pressure on the body saw. Excessive pressure may break the blade or
stall the body saw, potentially causing damage to the workpiece or
personal injury.
4. When you have finished cutting your line, pull the body saw from the
workpiece and release the throttle lever (13) to stop the body saw.
CARE & MAINTENANCE
1. Use the correct tool for the job. This tool was designed for a
specific function. Do not modify or alter this tool or use it for an
unintended purpose.
2. Do not carry the tool with fingers near or on the trigger/switch.
3. Avoid unintentional starts. Be sure that the regulator/throttle switch is
in the neutral or OFF position when not in use and before connecting it
to any air source.
4. Remove adjusting keys and wrenches from the tool before operation or
connecting it to a power source. A wrench or key that is left attached to a
rotating part of the tool increases the risk of personal injury.
5. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
Visit www.princessauto.com for more information
11
