Powerfist 11G-2-30H, User Manual

Page: 7 / 39

7
3.2 ASSEMBLY
1. Unpack the air compressor. Inspect the unit for damage. If the unit has been damaged in transit
complete a damage claim.
2. Check the compressor’s item number to confirm you have received the model ordered.
3. Ensure that adequate lifting equipment is available for moving the compressor. Follow good shop
practices and safety procedures.
4. Rubber feet are provided for items 8048530, 8057739 and 8077513.
CAUTION! The shipping pallet is not designed as a base for an operating compressor . Remove
the compressor from the pallet and place it on the floor or a hard, level surface. The compressor must
be level to ensure proper lubrication of the pump and good drainage of the moisture in the tank. We
recommend the use of rubber vibration pads under the feet for stationary units.
5. The flywheel side of the compressor must be at least 12 inches (31cm) from any wall or obstruction in
a clean, well-ventilated area to ensure sufficient air flow and cooling.
6. Connect discharge system components (not included) to the tank outlet.
3.3 PRE-OPERATION CHECKLIST
1. Remove all loose pieces and installation tools from the compressor and check for installation debris.
2. Unless otherwise specified, compressors are normally shipped without lubricant in the crankcase. Add
the correct amount of specified oil to the crankcase of the pump and the engine. Fill the tank of the
gasoline engine with unleaded gasoline.
3. Check engine and compressor pulleys for alignment and tightness on shaft.
4. Manually rotate the compressor pulley several rotations to be sure there are no mechanical
interferences.
5. Check belt tension.
6. Check all pressure connections for tightness and leaks.
7. Make sure all pressure relief valves are correctly installed.
8. Be sure all guards are in place and securely mounted.
9. Make sure the operating area is well ventilated.
10. Open all manual shutoff valves at and beyond the compressor discharge.
11. After all the above conditions have been satisfied, the unit can be started.