TC-610H PLUS Manual
IMPORTANT SAFETY INFORMATION
WARNING:
DO NOT
apply voltage and frequency different from those specified on voltage label at the bottom of the unit.
CAUTIONS:
1.
ONLY
operate the compressor in dry, well-ventilated areas on a flat surface.
2.
DO NOT
leave the compressor in operation unattended.
3.
DO NOT
insert any foreign objects into the compressor or disassemble/modify/repair it in any way.
4.
DO NOT
touch the compressor during or soon after operation since it will become hot.
5.
STOP
and turn off the compressor immediately if burnt odor, white smoke, odd noises, or other abnormalities are detected.
NOTE: Emission of an oil-like odor during the first few uses of a new unit is normal. The odor will gradually lessen and disappear.
Copyright © 2021 ANEST IWATA SPARMAX Co., Ltd. All rights reserved.
TC610H_PLUS_manual_20210428
1. Screw the Braided Air Hose onto the airbrush and Air Outlet.
NOTE: If your airbrush fitting is not 1/8” PS, select from the Aztek, Badger and Paasche airbrush adaptors included for your convenience, and screw
onto the airbrush and hose.
2. To connect to a 2nd airbrush, an additional hose not included is required. Remove the Outlet Cap and connect the 2nd hose. Depending on the air
consumption of the 2 airbrushes connected, the compressor may or may not support the simultaneous use of both airbrushes.
www.SPARMAXair.com
This manual contains important information on the correct operation, maintenance and safety information of
the compressor, all of which should be strictly adhered to. Failure to do so may cause damage of product
and/or potential hazards which are not covered under SPARMAX warranty.
Each SPARMAX compressor is tested and fully inspected to ensure its quality and performance are up to strict
standards at the time of factory dispatch.
PARTS DIAGRAM
SET UP
Check all parts are present and in good condition. Any transportation damages should be reported immediately to the original seller.
See voltage label at bottom of unit for specifications.
Braided Air Hose
On/Off Switch
Auto Stop Pressure Switch
Air Tank Safety Valve
Plug
Airbrush Holders (2)
Pressure Regulator
Knob
Outlet Cap
Air Outlets (2)
Filter
Filter Drain Valve
Pressure Gauge
Compressor Motor
Air Tank
Rubber Stands (4)
Handle
Air Tank Drain Valve
