4
©
All rights reserved. All trademarks are property of their respective owners.
3.
Storage
Please adhere to the following instructions if the UPS is not installed immediately:
Store the equipment as is in its original packing and shipping carton.
Do not store in temperatures outside the range of +15°C to +25°C.
Ensure that the equipment is fully protected from wet or damp areas and from moist air.
In order to maintain the vitality of the batteries, ensure that the UPS is recharged every 6 months
for at least 8 hours.
Storage and Transportation
Please handle the unit with extreme caution since a high amount of energy is contained with
the batteries. Always keep the unit in position as marked on the packaging and never drop the
unit.
4.
Installation
4.1 Environment
Please follow below instructions about locating the UPS system and battery option or the
safety of installation personnel cannot be guaranteed and the unit may malfunction.
Please ensure no flammable substances such as gases or fumes are present.
Avoid extreme temperature and humidity. Protect the equipment from moisture.
Ensure there are enough space at the behind and side of UPS for well ventilation.
Ensure that the front of the UPS remains clear for user operation.
Battery lifecycle could be extended with recommended temperature range of 15 °C to 25 °C.
Only a technician from the manufacturer or an authorized agent may service the unit.
Do not open UPS cabinet as the components may contain high voltage and may be fatal.
The output receptacles may carry live voltage even when it is not connected to power supply.
4.2 Connection to mains and loads
The input power cord needs to connect the rear inlet socket of the UPS and plug into a socket
on the wall. Please notice the voltage of utility power should match with the UPS. For example,
the rating voltage of UPS is 110V/(220V), the input utility power should be the same as
110V/(220V).
Connect the input cable to the UPS and connect the other end to a grounded outlet. The
batteries will automatically charge when connected to the mains. Please realize that although
you may start using the UPS immediately, maximum back-up time will still not be available, so
it is recommended to charge the batteries for a minimum of 8 hours before use.
Do not connect any devices that have the possibility of overloading the UPS or drawing
half-wave rectified current, such as hair dryers or vacuum cleaners.
Should computer or alarm connections be used, use connections according to chapter 5 of the
manual provided with that option. The connections can be referred to on the rear panel.
The installation is now complete.
CAUTION:
Never connect a laser printer or plotter to the “ UPS outlets”. A laser printer or plotter
periodically draws significantly more power than when its idle status, and may overload the UPS.
