5.5.1 Fill solution tank
Fill solution tank (Fig. 8/1) before work or as
required. Park vehicle on level ground.
Open tank lid (Fig. 8/5) and fill tank up to
the maximum (1/1 marker) (Fig. 8/2).
Alternatively, filling of the machine via quick
coupling (Fig. 8/6) is available. Before doing
so, connect the filling hose of the dosage
unit and the quick coupling. The floater
valve automatically closes after the
maximum filling level has been attained.
(Refer to specific operating instructions for
information on operation of the dosage unit)
The maximum admissible service pressure
of the floater unit is 87psi.
5.5.2 Empty solution tank
Park vehicle such that the fill level hose
(Fig. 8/3) is located above the drain
aperture in the floor. Take fill level hose
from holder and remove lid.
5.5.3 Solution Filter
Check solution filter (Fig. 8/4) at weekly
intervals and clean or replace if required.
Only clean solution filter when the
solution tank is empty.
1. Empty solution tank (Fig. 8/1), siehe Abschnitt 5.5.2.
2. Unscrew filter cap.
3. Remove the filter element from the filter case for
cleaning. Replace if required.
4. Re-install filter element and filter cap.