Owner’s Manual
R
PowerBoss, Inc. A Member of the Hako Group ©
2007
PowerBoss
®
CORE 50 Sweeper Scrubber
Page
54
PowerBoss
®
The Power of Clean
BRAKE ADJUSTMENT
1.
Park the machine on a level surface and turn on the scrubdeck to lower the
brushes to the floor. Turn off the engine.
2.
Chock both sides of the right front tire.
3.
Adjust the brakes for wear by locating the brake adjustment turnbuckle. This
is located beneath the frame to the rear of the brake equalizing bar and
directly below the brake pedal.
4.
Using a 9/16” open end wrench loosen the locking nut positioned against the
rear clevis. Back the nut away from the clevis several turns.
5.
Using the 9/16” wrench, turn the threaded bar by grabbing the hex section at
the center. If view from the rear of the machine, turning the bar
counterclockwise will tighten the brakes. Rotate the turnbuckle bar two full
turns.
6.
Retighten the locking nut against the rear clevis.
7.
Test the brakes. Readjust if required.
TIRES
CHANGING SOLID TIRES
1.
Remove the tire from the vehicle by removing the five inner lug nuts.
2.
Remove the five flathead bolts and nuts.
3.
Press the tire from the rim.
4.
Press the large rim half into the new tire.
5.
Mount the small rim half and secure with flathead bolts.
6.
Reinstall the tire on the machine.
SERVICE INSTRUCTIONS (CONTINUED)
BRAKES & TIRES
NOTE
The procedures which follow apply to SOLID TIRES ONLY.
