Owner’s Manual
R
PowerBoss, Inc. A Member of the Hako Group ©
2007
PowerBoss
®
CORE 50 Sweeper Scrubber
Page
21
PowerBoss
®
The Power of Clean
PRE-OPERATION
CHECKS
STARTING
SLOWING AND
STOPPING
Prior to starting the engine, check the following:
1. Engine oil level
2. Engine coolant level
3. Fuel level
4. Hydraulic fluid level
5. Brakes, steering and directional controls
6. The floor beneath the machine for signs of fluid leaks
Fluid levels should be correct. Brakes, steering and
directional controls should be functioning properly. Hoses,
lines and tanks should be free of damage and leaks.
Before starting the engine, sit in the operator’s seat
and make sure the parking brake is locked.
1. Make sure the directional control pedal is in the neutral
position.
2. Make sure the throttle is in the idle position.
3.
LP and Gasoline-powered
: Turn the ignition switch to
the
START
position, then release.
Diesel-powered
: Turn the ignition switch to the first
position, then press the glow plug switch for
approximately 15 to 20 seconds. Turn the ignition switch
to the
START
position and release.
If the engine fails to start, do not continue cranking for
more than ten (10) seconds. Allow the starter motor to
cool between attempts.
4. Allow the engine to warm for approximately two minutes.
1. Allow the directional control pedal to move into the
neutral position. The machine will slow and coast to a
stop.
OPERATING PROCEDURES
WARNING
NOTE
