Owner’s Manual
R
PowerBoss, Inc. A Member of the Hako Group ©
2007
PowerBoss
®
CORE 50 Sweeper Scrubber
Page
51
PowerBoss
®
The Power of Clean
SERVICE INSTRUCTIONS (CONTINUED)
HOPPER
FILTER REMOVAL
1.
Raise the hopper cover.
2.
Pull out both levers stored on the front of the filter retaining bracket.
3.
Push down on both levers at the same time to open and lock the filter
retaining bracket.
4.
Slide the filter forward to remove.
FILTER CLEANING
The dust control filter is a permanent type paper element filter. It may be vacuumed, blown
out with compressed air, tapped against the floor or washed with soap and water.
1.
If blown out with compressed air, use 100 psi or less.
2.
If washed with soap and water, use 40 psi water pressure or less.
FILTER REPLACEMENT
1.
If the retainer bracket is closed, push down both handles until the bracket
opens and locks.
2.
Install the panel filter. Make sure the filter is positioned all of the way in the
bracket. Gasket should be on the bottom.
3.
Unlock the retainer bracket and close by lifting up on the retainer bracket
handles.
4.
Pivot the handles in against the filter to their stored position.
5.
Close the hopper cover.
NOTE
Make sure the filter is thoroughly dried while standing on its
side before installing in the hopper. Do not install or use a wet
filter.
