PowerBoss Admiral 36, User Manual, Page: 5 / 36

The machine must not be operated in
areas endangered by risks of explosion.
The machine may be used only for
hard floorings in indoor areas and for
operation on plane areas with a
maximum inclination of up to 2%.
Driving e.g. on ramps with a maximum
inclination of 10% is only allowed for
transportation. Uphill drive must not
exceed 1 minute and particular care
has to be taken.
Repair, maintenance and cleaning
work must only be performed if the
master key is removed.
Before working on the electrical system,
be sure to disconnect the battery
plug.
Taking other persons than the
operator with the Admiral 36 is not
allowed. If the Admiral 36 is equipped
with a driver seat, it may only be
turned on when the operator is
seated (seat switch).
A perfect maintenance of the machine
mainly helps preventing accidents.
When performing repair, maintenance,
setting or other work the appropriate
tools have to be used. Other spare
parts than the genuine PowerBoss
spare parts must at least equal the
original parts as far as the safety
standards are concerned.
The Admiral 36 has to be checked by
an expert in regular inter-
5
Notes on warranty
intervals for its proper and safe opera-
tion (we recommend a check once
yearly at least) and after modification
or repair.
The Admiral 36 must be equipped
by brushes and pads as requires the
manufacturer (refer to section
”Technical data”). Using other brush-
es/pads than indicated affects your
safety.
Do not clean the machine by means of
vapor jet or high pressure cleaning
equipment.
For an increased danger of tilting, the
pneumatic tire equipment of the Ad-
miral 36 is not admissible.
Do not allow water to enter any elec-
trical parts.
The terms of the sales contact apply.
Damages are not subject to warranty
if they are due to non-compliance with
the maintenance and service
provisions. Any maintenance work has
to be performed by an authorized
PowerBoss
service work-shop and
confirmed in the „maintenance certifi-
cate“ which is the warranty document.
The following is excluded from
warranty:
natural wear and tear after overload,
fuses and damages caused by inex-
pent handling and unauthorized
modification of the machine.
Moreover, any claim for warranty
becomes extinct if damages at the
machine are caused by fitting of parts
or accessories without PowerBoss’s
prior and explicit consent or by non-
compliance with the maintenance in-
structions.