Maintenance work
Compliance with our recommen-
dations concerning maintenance
work will give you the certitude
ofalways having a machine at your
disposal, which is ready to work
and in good operating condition.
It is better to take precautions than
to repair damages – and less
expensive! Please contact your
local PowerBoss service center; the
people there will be glad to perform
that work for you. There, well-
trained personal and genuine
PowerBoss
spare parts are at your
disposal. In case of any inquiries or
orders for spare parts, please
always quote the machine’s serial
number mentioned on the
nameplate.
When cleaning or servicing the ma-
chine, and when replacing any parts,
shut off the motors and on principle
disconnect the battery plug; moreover
take precautions so as to protect the
unit against unintentional movements
or against being inadvertently started.
For reasons of safety during cleaning
and/or maintenance work in or on
the tank, the tank lid – when lifted –
must be secured so as to prevent
accidental closing or tilting down.
The machine may be taken into opera-
tion only if all guarding devices are
fitted and in protective position.
As far as possible, cleaning should
not be done by hand, but using
appropriate tools or equipment.
Maintenance, repair and adjustment
work may be carried out only by
means of suitable tools and by people
trained in the factory.
When using or replacing batteries,
battery connection cables, battery
charger units comply with the manu-
facturer’s instructions.
For reasons of safety, only genuine
PowerBoss
spare parts must be used.
Note:
Do not clean the machine by
means of vapor jet or high pressure
cleaning equipment but by means of a
water hose (pressure: approx. 5 to 6
bar) and from the top to the bottom.
Do not allow water to get into any
opening, slits, on electronic modules,
control panels or seals.
Do not allow water to get on the seat
console as it may be collected on the
battery stored below the seat.
Let the machine dry after cleaning
e.g. for the week-end. The use of
aggressive and caustic detergents is
not allowed.
The legal regulations and the local
provisions have to be complied with
when discharging detergents.
The Admiral 36 is equipped with a
service display. If a malfunction
occurs during operation, e.g. a
defective fuse, a 4-digit number will
appear in the display (hourmeter), the
4 dots will start flashing
simultaneously and the buzzer
sounds. This 4-digit number advises
the service technician in detail on the
last error found.
This facilitates fast repair action. The
following table lists some of the
possible errors displayed. You may
28
Summary of Contents for Admiral 36
Page 33: ...33...