PowerBoss Admiral 36, User Manual, Page: 14 / 36

Service display
The service display is located in the
hourmeter display.
When turning ON, the following
sequence of information will appear in
the hourmeter display:
– software status for 1 approx.
second, e.g.
– last error found, for approx. 2
seconds (points blink), e.g.
Note: If a defect is still existing, a
buzzer sounds and the red display
turns ON (F).
– hours run, e.g. during operation, the
dot will blink.
Note: on factory-new machines,
the display may read when the key
switch is turned to ON.
This is an internal control code; dis-
play will change to 0 hours after not
more than one hour.
The Admiral 36 is serviceable with
this display.
Error display is active either.
If a malfunction occurs during ope-
ration, a 4-digit number will appear
in the display, the 4 dots will start
flashing simultaneously and the
buzzer sounds.
Refer to page 61 for the error code
numbers which you may remedy by
yourself. If the machine does not
operate correctly despite measures
taken, denote the error code and
advise your PowerBoss service
H Pilot lamp for battery charge
condition
Upon turning ON the key switch, all
green pilot lamps (b to d) alight in
case of a perfectly charged battery.
During operation the lamps b, c
and d will successively extinguish
as the battery discharges.
A flashing red light (a) indicates that
operation will soon be interrupted
and the buzzer sounds. After 3
more minutes, the red lamp alights
permanently and the brush dive
and the suction turbine will be
switched OFF. The travel drive
assembly remains activated. We
recommend to recharge the batte-
ries at the charging station as soon
as possible.
I Key for additional scrubbing and
vacuuming tool
Note:
this key is only operable if
the Admiral 36 is equipped with
the ”additional scrubbing and
vacuuming tool” option and the
PowerBoss
service center has
programmed the machine
accordingly. Otherwise, ”-OP-” is
displayed. This key turns the water
pump and the suction turbine ON
and OFF. The water and the
vacuuming hose of the scrubbing
tool have to be connected
14
3. 0 1 5
1. 2. 6. 1.
0 2 1 5.
9 9 9 9.