PowerBoss, Inc. Copyright 2010
PB# 4100039 Rev.* 06/10
Armadillo 9X Series Sweeper
Page 30
8. Turn the clevis clockwise three or four
complete turns.
9. Tighten the jam nuts and re-install the clevis
ends onto the bar.
10. Adjust the knurled handle on the parking
brake lever.
TIRES
Changing Solid Tires
NOTE: The procedures which follow apply to
SOLID TIRES ONLY.
1. Remove the tire from the vehicle by removing
the five inner lug nuts.
2. Remove the ten hex head bolts and nuts.
3. Press the tire from the rim.
4. Press the large rim half into the new tire.
5. Mount the small rim half and secure with hex
head bolts.
6. Reinstall the tire on the machine
Changing Pneumatic Tires
CAUTION
Changing pneumatic tires must be performed
in a safety cage and require special tools,
PowerBoss, Inc. recommends that you have
these tires changed by a professional tire
dealer. (They are to be inflated to 110 psi.)
MISCELLANEOUS ADJUSTMENTS
Anti-Static Chain Adjustment
Each machine is equipped with an anti-static
chain bolted to the back wall of the broom
chamber. This should remain in contact with
the floor at all times. Inspect the chain every
200 operating hours. Replace if at least one link
does not drag the surface of the floor.
Latch and Hinge Maintenance
Latches and hinges should be inspected after
every 500 hours of use. Retighten and oil if
necessary.
Cables
Inspect all cables for wear every 500 hours.
BRAKE CABLE
CLEVIS END
JAM NUT
TROUBLESHOOTING AND REPAIR
