PowerBoss, Inc. Copyright 2010
PB# 4100033 Rev.* 06/10
Armadillo 9X Series Sweeper
Page 23
Filter Removal
1. Release the latch on the hopper cover and
raise the cover.
2. Disconnect the wire harness leading to the
filter shaker motor.
3. Unscrew the four screws (each attached using
one conical washer and an isolator) securing
the filter retainer bars to the hopper.
4. Remove the shaker motor assembly and filter
retainer bars.
5. Lift out the panel filter.
Filter Cleaning
The dust control filter is a polyester type element
filter. It may be vacuumed, blown out with
compressed air, tapped against the floor or
washed with soap and water.
1. If blown out with compressed air, use 100 psi
or less.
2. If washed with soap and water, use 40 psi
water pressure or less.
NOTE: Make sure the filters are thoroughly dried
while standing on their side before
installing in the hopper. Do not install or
use a wet filter.
Filter Replacement
1. Insert the panel filter.
2. Install the shaker motor assembly.
3. Install and tighten the four filter retaining
screws and isolators.
4. Hook the wire harness to the filter shaker
motors.
5. Close the hopper cover and secure the latch.
HOPPER
BACKING
PLATE
NUTS AND
WASHERS
SCREWS AND
WASHERS
WIRE HARNESS
CONNECTIONS
SHAKER
MOTOR
ASSEMBLY
HOPPER
LATCH
MOTOR WIRE
HARNESS LEAD
PANEL
FILTER
TROUBLESHOOTING AND REPAIR
