Page 18 — English
MAINTENANCE
USING THE BATTERY MAINTAINER
See Figure 24.
When storing the generator, the battery maintainer can be
connected to keep the battery fully charged and ready for use.
NOTE:
The battery maintainer provided should only be used
with the 12V 9Ah/20HR lead acid battery model RT1290H
supplied with this generator.
Connect the battery maintainer to the power supply. Make
sure the power supply is normal household voltage, 120
volts, AC only, 60 Hz.
Attach the other end of the battery maintainer to the
charging cable attached to the battery. The red light on
the plug will illuminate to show the battery is charging.
The battery will become slightly warm to the touch while
charging. This is normal and does not indicate a problem.
When battery is fully charged, the red light will turn green.
NOTE:
If the light does not illuminate, the fuse on the
charging cable may need to be replaced. Check the fuse
and replace if needed.
Disconnect the battery maintainer before operating the
generator. Place the cover on the charging cable when
not in use.
BATTERY REMOVAL AND PREPARATION
FOR RECYCLING
To preserve natural resources, please recycle
or dispose of batteries properly.
This product uses lead acid batteries. Local,
state or federal laws may prohibit disposal of
batteries in ordinary trash.
Consult your local waste authority for information regarding
available recycling and/or disposal options.
WARNING:
Upon removal, cover the battery’s terminals with heavy-duty
adhesive tape. Do not attempt to destroy or disassemble
battery or remove any of its components. Lead acid batter-
ies must be recycled or disposed of properly. Also, never
touch both terminals with metal objects and/or body parts
as short circuit may result. Keep away from children. Failure
to comply with these warnings could result in fire and/or
serious injury.
BATTERY CHARGER FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Opera-
tion is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must
accept any interference received, including interference that
may cause undesired operation.
WARNING:
Changes or modifications to this unit not expressly ap-
proved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment on and off, the user is
encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
Summary of Contents for PS907000S
Page 26: ...Page 22 English NOTES ...
Page 47: ...Pàgina 22 Español NOTAS ...