Power Stroke PS907000S, Operator'S Manual

Page: 15 / 48

Page 11 — English
UNPACKING
This product requires assembly.

Carefully cut the box down the sides then remove the
machine and any accessories from the box. Make sure
that all items listed in the loose parts list are included.
NOTE
: This machine is heavy and requires a minimum of
two people to lift. To avoid back injury, lift with your legs
and not your back.
WARNING:
Do not use this product if any parts in the Loose Parts List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.

Inspect the unit carefully to make sure no damage oc-
curred during shipping.

Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.

If any parts are damaged or missing, please call
1-877-617-3501 for assistance.
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result in
serious personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious per-
sonal injury.
WARNING:
Do not attempt to operate the generator until assembly
is complete. Failure to comply could result in possible
serious personal injury.
LOOSE PARTS LIST
See Figure 3.
The following items are included with the generator:
Key
No.
Description Qty.
1 Wheel ...................................................................2
2 Axle ......................................................................2
3 Washer .................................................................2
4
Hitch Pin ..............................................................2
5 Lock Nut (M6) ......................................................4
6 Legs with Rubber Feet (Left and Right) ...............2
7 Bolt (M6 x 50mm) ................................................4
8 Handle Lock Pin ..................................................1
9 Lanyard ................................................................1
10
Engine Lubricant..................................................1
11 Battery Maintainer ...............................................1
Operator’s Manual (not shown) ...........................1
TOOLS NEEDED
See Figure 4.
The following tools (not included or drawn to scale) are
needed for assembly:

Socket Wrenches and/or Combination Wrenches

Phillips Screwdriver
NOTE : Do not put fuel or lubricant in the generator before
installing the legs, frame support, wheels and handle.
INSTALLING LEGS
See Figure 5.

Locate the following items:
Legs with rubber feet (left and right)
4 lock nuts (M6)
4 bolts (M6 x 50mm)
 Raise the front end of the generator, where the engine is
located, high enough to gain access to the frame bottom;
securely position props underneath to support.
 Slide a leg onto the the frame support. Position the leg so
that the holes in the leg align with the holes in the frame.

Insert bolt through hole in the frame and the leg.

Fasten the bolt by installing a lock nut over bolt on the inside
of the frame. Tighten the nut securely.
 Repeat with remaining leg.
ASSEMBLY