Power Stroke PS907000, Operating Instructions Manual

Page: 16 / 48

Page 12 — English
INSTALLING THE FRAME SUPPORT
See Figure 4.
Install the frame support on the bottom of the generator
frame on the same side as the handle.

Locate the following items:
Frame support
2 lock nuts (5/16-18)
4 large washers (5/16 in.)
2 bolts (5/16-18 x 1 in.)

Raise the end of the generator where the recoil starter is
located high enough to gain access to the frame bottom;
securely position props underneath to support.

Align the holes on the frame support with the holes on
the generator frame.

Thread washer over the bolt, then insert the bolt through
the hole in the generator frame so it extends down through
the frame support.

Slide a washer on the bolt, then install lock nut. Tighten
nut securely.

Repeat on other side.
INSTALLING THE WHEELS
See Figure 5.
Wheels are provided to assist in moving the generator to
the desired location and should be installed on the side
opposite the handle.
If you have the bolt/spacer/lock nut hardware:

Locate the following items:
2 large bolts
2 washers
2 spacers
2 wheels
2 large lock nuts

Raise the end of the generator opposite the handle high
enough to gain access to the frame bottom; securely
position props underneath to support.

Insert a wheel spacer into the center of the wheel.
 Place a washer on the bolt, then slide bolt through the
wheel.

Slide the bolt through the U-bracket frame on generator.

Install nut on bolt and tighten securely.
 Repeat the process on the other side to install second
wheel.
If you have the axle/hitch pin hardware:

Locate the following items:
2 axles
2 hitch pins
2 washers
2 wheels

Raise the end of the generator where the handle is located
high enough to gain access to the frame bottom; securely
position props underneath to support.

Slide the axle through the hole in the center of the wheel.

Slide a washer onto the axle, then slide the axle into the
wheel mounting hole as shown.

Insert hitch pin to secure.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.

Repeat with the second wheel.
ATTACHING THE HANDLE
See Figure 6.

Locate the following items:
2 handles
2 bolt (5/16-8 x 3/4 in.)
4 small washers (5/16)
2 lock nuts (5/16)
2 handle bracket spacers

Place handle and spacer on the frame.

Place a washer on a bolt, then slide bolt through the
handle, the frame and the spacer.

Slide a washer on the bolt, then install nut and tighten
securely.

Repeat the process on the other side to install second
handle.
LOCKING THE HANDLE
See Figures 7 - 8.

Locate the following items:
2 handle lock pins
2 lanyards
 Attach the lanyard to the handle lock pin and the handle
as shown in figure 7.

Extend the handle, then insert the pin through the hole
in the handle and the generator frame to secure handle
in place.
 Repeat the process on the other side to lock the other
handle.
CAUTION:
Do not attempt to lift the unit by the handle assembly. If
it is necessary to lift the generator, always grasp by the
frame. Use proper lifting techniques to avoid back injury.
ASSEMBLY