8976052
MINIMIG 100E Flux-Cored Welder
V4.0
10
For technical questions call 1-800-665-8685
5.
Always use both hands when operating the tool, unless the tool is
designed for single hand use.
6. Hold the tool by the insulated gripping surfaces when performing an
operation where it may contact hidden wiring or its own cord. Contact
with a ‘live’ wire will electrify exposed metal parts and shock the operator.
7.
Do not allow the tool's motor to overload and/or overheat by taking work
breaks.
8. When the tool is in operation, keep hands away from the welding wire and
the area it is being applied to.
9. Do not connect the welding unit ground clamp to an electrical conduit. Do
not weld on an electrical conduit.
10. Do not use the tool on any material containing asbestos.
11. Do not touch the welding wire or welded surface immediately after use.
The surface will be hot and may cause an injury.
12. Do not allow persons who are not familiar with the tool or have not read
these instructions to use the tool.
POWER CORD
1.
Insert the power cord plug directly to the power supply whenever possible.
Extension cords are not recommended for use with this welding unit.
2. Do not operate this tool if the power cord is frayed, damaged or poorly
spliced, as an electric shock may occur, resulting in personal injury or
property damage.
a.
Inspect the tool's power cord for cracks, fraying or other faults in the
insulation or plug before each use.
b. Discontinue use if a power cord feels more than comfortably warm
while operating the tool.
c.
Have the power cord replaced by a qualified service technician.
3.
Keep all connections dry and off the ground to reduce the risk of electric
shock. Do not touch plug with wet hands.
4.
Prevent damage to the power cord by observing the following:
a.
Never use the cord to carry the tool.
b. Do not pull on the cord to disconnect the plug from an outlet.
c.
Keep the power cord clear of the tool and the tool's work path while
in operation. The cord should always stay behind the tool.
