Power Electronics SD700SP Series, Hardware And Installation Manual

Page: 10 / 61

SD700SP POWER ELECTRONICS
8
SAFETY INSTRUCTIONS
RECYCLING
Equipment packaging must be recycled. Separate all different materials (plastic, paper, cardboard,
wood…) and place them in the corresponding containers. Ensure waste collection is properly
managed with a Non-Hazardous Waste Agent.
To guarantee health and natural environmental sources protection, the European Union
has adopted the WEEE directive concerning discarded electric and electronic equipment
(SEEA).
Waste of electrical and electronic equipment (WEEE) must be collected selectively
for proper environmental management.
Our products contain electronic cards, capacitors and other electronic devices that should
be separated when they are no longer functional. These WEEEs should be managed
accordingly with a Hazardous Waste Agent.
Power Electronics promotes good environmental practices and recommends that all its
products sold outside of the European Union, once they reach the end of their life, are
separated and the WEEE managed according to the particular country applicable
legislation (especially: electronic cards, capacitors and other electronic devices)
If you have any questions about the electric and electronic equipment waste, please contact
Power Electronics.
SAFETY
•
Before operating the drive, read this manual thoroughly to gain and understanding of the unit.
If any doubt exists then please contact POWER ELECTRONICS, (902 40 20 70 / +34 96
136 65 57) or your nearest agent.
•
Wear safety glasses when operating the drive with power applied or the front cover is
removed.
•
Handle and transport the drive following the recommendations within this manual.
•
Install the drive according to the instructions within this manual and the local regulations.
•
Do not place heavy objects on the drive.
•
Ensure that the drive is mounted vertically and keeping the minimum clearances distances.
•
Do not drop the drive or subject it to impact.
•
The SD700SP drives contain static sensitive printed circuits boards. Use static safety
procedures when handling these boards.
•
Avoid installing the drive under conditions that differ from those described in the
Environmental Ratings section.
CONNECTION PRECAUTIONS
•
To ensure correct operation of the drive it is recommended to use a SCREENED CABLE for
the control wiring.
•
The motor cable should comply with the requirements within this manual. Due to increased
leakage capacitance between conductors, external ground fault protection threshold value
should be adjusted ad hoc.
•
Do not disconnect motor cables if input power supply remains connected.
•
The internal circuits of the SD700SP Series will be damaged if the incoming power is
connected and applied to output terminals (U, V, W).
•
Do not use power factor correction capacitors banks, surge suppressors, or RFI filters on the
output side of the drive. Doing so may damage these components.
•
Always check whether the DC Link red LED is OFF before wiring terminals. The capacitors
may hold high-voltage even after the input power is disconnected.