Power Craft 89040, Instruction Manual

Page: 21 / 29

21
ENGLISH
INSTRUCTION MANUAL
Scale for thinning
Spray liquids: Thinning DIN/sec.
Impregnation fluids, Unthinned – 30
primer, varnish and lacquer.
Synthetic plastic 15 – 30
paint and clear lacquer.
Acrylic paint 20 – 30
Wood preservative, Unthinned – (Max. 30)
pesticides, oils.
Aluminium paint 15 – 30
Cleaning agents and Unthinned – (Max. 30)
polishes.
Start up
Before connecting to the mains, check that mains
electricity complies with that stated on label
attached to gun.
NOTE: Do not use with no liquid in the container.
This will ruin the pump and invalidate the
guarantee.
Refilling the container (2)
1. Place container on a piece of paper and fill.
2. Check correct thinning. (3)
3. Screw gun onto container (4).
Adjust spray with adjustment
knob (5)
1. Before starting, turn adjustment knob
anticlockwise to maximum.
2. Press Start button and turn adjustment knob
backwards until best result is achieved.
- Clockwise reduces pressure.
- Anticlockwise increases pressure.
Correct spray technique
1. To achieve best result hold spray gun 23-30
cm from surface to be sprayed. This prevents
air getting into the pump until the liquid
runs out.
2. Uneven spray movements will cause bubbles
and runs in the paint. Always use smooth,
even arm movements.
3. Use arm, not wrist. (6 – 7)
Some tips
•
Always clean the surface first for the best
result. Clean and protect surface from dust.
•
Check for correct setting by trying out on
a price of board or the like.
•
Use good quality paint. This will help avoid
runs. If applying more than one coat, allow
each coat to dry properly before applying the
next.
•
Cover all other surfaces to avoid accidental
spraying.
•
See illustration number (8) for the best
method.
•
Remember that excess paint can fall on the
surrounding areas.
Cleaning
1. Always fill with a little thinners after painting
is finished to clean internal parts. Remember
not to exceed the flashpoint of 21º C.
2. Disconnect from the mains.
3. Dry outer surfaces and parts with a dry cloth.
Never submerge the gun in a liquid. (9)
4. Remove the container, valves and paint nozzle.
Remove suction pipe. (10)
5. Clean bowl, valves, nozzle and suction hose
with a brush (11)
6. Place a couple of drops of oil in the pump to
protect against corrosion. (12)