What is a Biscuit Jointer used for?
A Biscuit joiner is a woodworking tool used to join two pieces of wood together.
How does a biscuit jointer work?
A biscuit joiner uses a small (4”) blade to cut a crescent shaped hole in the
opposite edges of two pieces of wood. An oval shaped wooden biscuit is cov-
ered with glue, placed in the slot, and the two boards are clamped together.
What size biscuits should I use in my joints?
Generally you should try to use the largest biscuit that will fit.
What to do if the cutting depth is not correct?
When the cutting depth is not correct, It can be adjusted as following:
Move the motor base (14) as far as possible backwards
Loosen the Pin. Set the cutting depth by turning the screw, the screw is posi-
tioned at the back of the pin. Repeat the procedure till the cutting depth is
correct.
Fasten the Pin.
What’s the difference between a biscuit jointer and a plate jointer?
There is no difference. Both names refer to the same tool. The term “Biscuit
Jointer” is used more commonly in the U.S. than Plate Jointer.
Environment
Should your appliance need replacement after extended use, do not
discard it with the household rubbish but dispose of it in an
environmentally safe way.
Waste produced by electrical machine items should not be handled like
normal household rubbish. Please recycle where recycle facilities exist. Check
with your Local Authority or retailer for recycling advice.
15
14
Helpline No. UK / Northern Ireland 0870 112 1948 Rep. Ireland 0800 32 929292
Web Support:
www.clickspares.co.uk
Model Number: 6851
Helpline No. UK / Northern Ireland 0870 112 1948 Rep. Ireland 0800 32 929292
Web Support:
www.clickspares.co.uk
Model Number: 6851
FAQ
Other useful information
Race the biscuit dowel in the groove of one work piece.
Place the other work piece on the biscuit dowel.
Fasten the work pieces and wait till the glue is dry.
8. CHECKING THE CUTTING DEPTH
Always check the cutting depth after mounting a saw blade.
Disconnect the plug from the socket.
Move the motor base (14} as far as possible backwards.
Set the cutting depth in the maximum position by turning the depth adjust-
ment knob (7).
Move the motor base forwards till the pin will fall in the notch of the adjust-
ment knob (7)
Turn the saw blade till one tooth of the saw blade is in the front position.
Measure the distance from the side of the base plate to the tooth of the saw blade.
Check if the distance is 19mm. The maximum position is 18mm.
9. SETTING THE CUTTING DEPTH
When the cutting depth is not correct, It can be adjusted as following:
Move the motor base (14) as far as possible backwards
Loosen the Pin.
Set the cutting depth by turning the screw, the screw is positioned at the
back of the pin.
Repeat the procedure till the cutting depth is correct.
Fasten the Pin.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
