![background image](http://html.mh-extra.com/html/power-craft/31111/31111_original-manual_1586373053.webp)
53
NO
SE
FI
GB
DE
DK
PL
ET
Table saw
(4. 5. 6. 7. 8. 9. 18, B1. B5. B6. B7. B8. B9. B16, A)
8. Take out the inside of foam and put the
work bench (4) in the foot frame (B1).
Using four hexagonal screws to put work
bench and base plate (B16) � xed in the
feet frame.
9. Adjust handle wheel (A) , the saw blade
rose to the hightest position.
10. Install the saw guard (5) on the knife
plate (10) and tighten it (B5).
11. Install the dust pipe (6) , refer to (B6) , you
can then connect a suitable industrial
vacuum cleaner or an extraction system
to this.
12. Slide the dial (7) into the guide on the
table (B7).
13. Slide the longitudinal fence (8) into the
guide on the table (B8).
15. The knob can be adjust the fence (B9) ,
the straight line fence can be � tted and
used as a longitudinal fence lateral fence.
Table 2 side extension plate / back
extension plate
(11. 12. 13. 14. 15, B10)
16. First install the 2 side extension plate on
the work bench, use the open wrench
(15) to screw the two long support leg
(13) on the 2 side extensions plate (11)
(12).
17. Second install the back extension plate
on the back work bench, screw the two
long support leg on the back extension
plate (14).
18. Adjusting the level around the work
bench and three extension plate, tighten
the all screws (B10).
Install machine
(5. 10, B14)
19. Adjust the knife plate (10).
20. Remove the saw guard (5).
21. Use open-ended spanner to adjust the
two hexagonal nuts, set the knife plate to
a distance of 3-5mm with the saw blade
(B14).
Replace the saw blade
(5. 9. 16, 17, B15. B10. B11, A. B. C. D)
22. Wear working gloves.
23. Remove the saw guard (5).
24. Adjust handle wheel (A) , the saw blade
down to the lowest position.
25. Use saw wrench (16) fastening the saw
blade pressure plate. and use socket
wrench (17) unscrew the screws on the
output shaft (B15).
26. Remove the blade.
27. Before replace a new blade. Must be
chean the dirt on the output shaft.
Important:
• Remember the direction of rotation.
The teeth must point to the front of the
machine.
• Finally install the saw blade guard.
Summary of Contents for 31111
