![background image](http://html.mh-extra.com/html/power-craft/31111/31111_original-manual_1586373054.webp)
54
GB
• Turn the hand wheel (A) anti-clockwise =
Greater cutting depth.
• Turn the hand wheel (A) clockwise =
Smaller cutting depth.
Vertical angle cuts
• By undoing the locking lever (B) you can
swing the saw blade and the entire drive
unit to the right at any angle between 90
and 45 degrees using the hand wheel (A).
• Always ensure that the riving knife is
� ush with the saw blade.
• Tighten the locking lever and make the
cut.
Horizontal angle cuts (mitre cuts)
• Set the dial to the required angle.
• Fit the fence (9) and carefully move the
workpiece against the saw blade.
• You can keep the lateral fence ready to
hand in the mounting on the right-hand
side of the machine.
Longitudinal cuts
• Set the parallel fence to the required
width to the saw blade. You can select
either a low or high guide level.
• Place the workpiece against the fence
with the � at/wider side � at on the saw
table.
• Hold wide workpieces on both sides with
your hands (wear safety gloves ) and
move them past the saw blade.
Important: Keep your hands well away from
the saw blade.
• Slide narrow workpieces along the saw
lade using the pushing hands (D).
Additional:
• If need notch function, must need the
extral support spare parts.
Working with the table circular saw
• Ensure that all the moving parts move
easily, that the saw blade turns freely and
that the mains voltage is identical to the
voltage on the model plate.
• Open the safety ON/OFF switch (C) by
pulling up the safety cover (B10) and
push the switch to I=ON (B11).
• To turn it off push the switch to O=OFF.
• The locked cover can be secured with a
padlock to prevent it being switched on
without authorisation.
• Set the required cutting depth using the
had wheel (A).
• Switch on the machine and wait until the
saw blade reaches maximum speed.
• Place the workpiece on the lateral or
parallel fence and carefully push the
workpiece into the saw blade.
• To use all the facilities of the table circular
saw to the full, you should purchase
material on professional woodworking
from a specialist bookshop.
Service and Maintenance
• Before performing any work on the
equipment, pull the power plug.
• Use a damp cloth to clean the plastic
elements. Do not use any cleansers,
solvents, or pointed objects.
• Regularly clean any dust that is stuck to
the ventilation openings and moving
parts with a soft brush or a paint brush.
• Regularly it all moving metal parts.
Summary of Contents for 31111
