![background image](http://html.mh-extra.com/html/power-craft/14-4-volt-cordless-hammer-drill/14-4-volt-cordless-hammer-drill_user-manual-and-warranty-information_1586267011.webp)
HELPLINE No. U K 0905-1460005 • IRELAND 1520-932626
WEB SUPPORT: www.heltec.eu
11
Mounting accessories
Prior to mounting an accessory always remove the battery.
Attaching and removing drill bits
Fig. B
In addition to drilling, the device can also function as a screwdriver and
accommodate bits with hexagonal shafts.
•
Loosen the drill chuck (1) by turning it by the flanging (B).
•
Insert the shaft of the drill bit into the receptacle of the drill chuck.
•
Tighten the drill chuck until the shaft of the drill bit is firmly in place and you
hear a click noise.
•
Loosen the drill chuck if you want to change the drill bit.
•
Before connecting the charger, ensure that the outer surface of the battery or
tool is clean and dry.
•
Only use single bits in combination with the bit extension piece. The extension
piece is not suitable for double sided bits.
1
B
HELPLINE No. U K 0905-1460005 • IRELAND 1520-932626
WEB SUPPORT: www.heltec.eu
14
Operation
Adjusting the torque
Fig. E
The appliance has 16 different torque settings with which to set the power
for driving and removing screws.
•
Set the torque adjustment ring (3) to the desired position. The available
torque settings are indicated on the adjustment ring by the numbers 1 to 16.
•
You should preferably choose as low a setting as possible when using the
screwdriver. Select a higher speed setting for drilling.
Driving and removing screws
•
Set the direction reversing switch (5) to position 'R' in order to drive
screws.
•
Set the direction reversing switch to position 'L' in order to remove screws.
Drilling
•
Rotate the torque adjustment ring (3) to the drilling position.
Ensure that the direction reversing switch (5) is always set to 'R'
during drilling.