HELPLINE No. U K 0905-1460005 • IRELAND 1520-932626
WEB SUPPORT: www.heltec.eu
09
Safety instructions
Important safety notes on charger and battery
If you come into contact with acid from the battery, rinse it off
with water immediately. If acid gets into your eyes, rinse out your
eyes at once with water and contact a doctor immediately!
1. Please read the manual before using the battery and charger.
2. NB! Only use the charger and battery provided by the manufacturer.
3. Protect the charger, battery and power tool from moisture, e.g. rain or
snow.
4. Always check that all cables are connected correctly before using the charger.
5. If you discover that a cable is damaged, you should not use the charger
again. Have the damaged cable replaced immediately.
6. When the charger is not in use, the mains plug should be removed from
the power socket. Do not pull out the plug by tugging the cable.
7. If the charger has been dropped or has otherwise been exposed to high
mechanical stresses, you should have it checked for damage by an
authorised dealer before using it again. Damaged parts should be
repaired immediately.
8. Never attempt to repair the charger or battery yourself. Repairs must
always be carried out by an authorised dealer.
9. Before cleaning or servicing the charger or battery, unplug the drill from
socket.
10. Never charge the battery when the ambient temperature is below
5 °C or above 40°C.
11. The air vents in the charger must never be blocked.
A short-circuit will cause a high current to flow. This may result in
overheating, the danger of fire or explosion of the battery. This
may damage the battery or the user may risk an accident.
Therefore:
•
Take care that there are no metal objects (nails, paper clips, coins, etc.)
in contact with the surface of the battery .
•
Do not expose the battery to water or rain.
•
Only use the battery supplied in combination with this cordless
hammer drill/screwdriver so as to avoid faults and/or risks to persons.
HELPLINE No. U K 0905-1460005 • IRELAND 1520-932626
WEB SUPPORT: www.heltec.eu
16
Operation
Tips
•
Use only bits that fit properly in the head of the screw.
•
When driving larger and/or longer screws into hard materials, it is
advisable to drill a pilot hole first.
•
For drilling in metal, use only perfectly sharpened HSS drills.
