UK Helpline 0905-460005 • Ireland Helpline 1520-932626
Web Support: www.heltec.eu
Model Number: PAG-125/1020
09
Safety instructions
customer service centre unless otherwise indicated elsewhere in this
instructions manual. Have defective switches replaced by our customer
service centre. Do not use tool if the switch does not turn on and off.
21. Warning.
The use of any other accessory or attachment other than recommended in
this operation instructions or the catalogue may present a risk of personal
injury.
22. Have your tool repaired by an expert.
This appliance is manufactured to very high standards and meets relevant
safety regulations. Repairs should only be done by a suitable qualified
electrical engineer or otherwise.
23. Hearing protection should be worn.
24. Never use a power tool with a defective switch.
Any power tool which can no longer be switched on or off is dangerous
and must be repaired.
25. If the connecting line is damaged, it must be replaced by the
manufacturer or by the manufacturer’s customer service representative to
protect people from hazards.
Additional safety instructions
•
Check that the maximum speed indicated on the grinding disc corresponds
to the maximum speed of the machine. The speed of the machine must not
exceed the value on the grinding disc.
•
Make sure that the dimensions of the grinding disc correspond to the
specifications of the machine.
•
Make sure that the grinding disc has been mounted and fastened properly.
Do not use reducing rings or adapters to make the grinding disc fit
properly.
•
Treat and store grinding discs in conformance with the supplier’s
instructions.
•
Do not use the machine for grinding workpieces with a maximum thickness
exceeding the maximum grinding depth of the grinding disc.
•
Do not use grinding discs for deburring.
•
When grinding discs have to be mounted on the thread of the spindle,
make sure that the spindle has sufficient thread. Make sure that the spindle
is sufficiently protected and does not touch the grinding surface.
•
Before use, inspect the grinding disc for any damage. Do not use grinding
discs which are crack-ed, ripped or otherwise damaged.
•
Before use, let the machine run idle for 30 seconds. Immediately switch off
