- 29 -
1300_GB-ANHANGB_GELENKWELLE
PTO SHAFT
GB
Supplement - B
Instructions for working
The permissible pto speed may not be exceeded when
using the implement.
- The hitched implement may continue to run after the
pto is switched off. Work may only be performed once
it has reached complete standstill.
- The cardan shaft must be put down or secured using a
chain when the implment is parked. Do not use safety
chain (H) to suspend the cardan shaft.
Wide-angle joint:
Maximum angle in operation and at standstill 70°.
Standard joint :
Maximum angle at standstill 90°.
Maximum angle in operation 35°.
Maintenance
Replace work covers immediately.
- Lubricate with a brand-name grease before starting
work and every 8 hours worked.
- Before any extended period of non-use, clean and
lubricate driveshaft.
For winter working, grease the tube guards, to avoid
them freezing together.
Matching driveshaft to tractor
To determine the actual length required, hold the two halves
of the driveshaft side by side.
T rimming procedure
- To adjust the length, place the pto halves in the shortest
operating position (L2) next to one another and mark.
Caution!
• Note the maximum operating length (L1)
- Aim at the maximum possible tube superimposition
(min. 1/2 X)
• Trim the inner and outer protective tube equally
• Attach overload fuse (2) at the implement!
• Always check that drive shaft locks are securely engaged
before starting work.
Safety chain
- Use chain to prevent tube guard from rotating.
Ensure sufficient swivel space for the cardan shaft!
- Trim the safety chain so that it cannot wind around the
cardan shaft.
8
Be advised!
Only use the
cardan shaft sup-
plied or stated;
otherwise the
warranty claims
for any damage
are not valid.
