34
The exhaust air duct installation kit consists of (see Figure 4.4 Fume outlet on page 34):
• n. 1 exhaust air pipe Ø 80mm (length 300 mm) with terminal;
• n. 1 rain cover;
• n. 1 curve 90° Ø 80 mm.
To assemble and fi t the external exhaust fumes installation kit, proceed as follows:
You will need:
the appliance positioned in its installation site (refer to Figure 4.4 Fume
outlet on page 34).
1. Fit the rain cover (C) on the elbow 90° (A).
2. Fit the elbow 90° (A) to the clamp on the left side of the appliance.
3. Fit the terminal/pipe assembly (B) to the elbow (A).
Figure 4.4
– Fume outlet
LEGEND
A
Elbow 90° Ø 80
B
Pipe Ø 80 Lg.300 mm w/terminal
C
rain
cover
4.8
PROGRAMMING OF HYDRAULIC PARAMETERS
The operations described in this paragraph are necessary only if the appliance is not
connected to a DDC or to a CCP.
If the appliance is connected to a DDC, follow the instructions given in the DDC manuals
exclusively.
This paragraph explains how to set the hydraulic parameters on the electronic board
of the appliance. Users not familiar with the basic procedures for the use of the board
should refer to Section 3.2 ON-BOARD ELECTRONICS on page 17.
To confi gure the appliance, access menu 3 of the electronic board.
With regard to the hydraulic confi guration, six parameters may be set: select the letter E
to exit to the previous menu.
