Potensic Dreamer Pro, User Manual, Page: 19 / 29

17
About Flight
This chapter introduces flight environment requirements, precautions, and flight operation procedures.
1. Flight Environment Requirements
1. Please do not fly in bad weather, such as strong wind (wind speed 5 and above), snow, rain, foggy
weather, etc.
2. Choose an open place without surrounding tall buildings as the flight site. Buildings that use a lot of
steel will affect the geomagnetic work, and will block the GPS signal, resulting in poor positioning of
the aircraft or even unable to locate.
3. When flying, please keep your eyes in control and keep away from obstacles and crowds.
4. Please do not fly in areas with high voltage lines, communication base stations or transmission
towers to avoid interference from the remote control.
5. Flying above 5000 meters above sea level, due to environmental factors, the performance of the
aircraft battery and power system will be degraded, and the flight performance will be affected.
Please fly with caution.
2. Flight Precautions
1. Check whether the remote controller, intelligent flight battery and mobile device have sufficient
power.
2. Check whether the fuselage is complete and the propeller is correctly installed.
3. Check whether the camera works normally after the power is turned on.
4. Check if the App is running normally.
5. Check if the SD card is inserted, make sure the camera is clean.
6. Low battery protection: Low battery alarm is triggered when the power is less than 20%. Based on
the distance between the current position and the Home point, the aircraft will intelligently trigger a
low-power return.
7. Loss of connection protection: It is triggered after 3 seconds of loss of connection; the re-connection
is successful during the return flight, and it can be canceled manually.
8. Out-of-control protection: After the aircraft's horizontal tilt angle is over 80 degrees for 2 seconds,
the motor will automatically stop.
Because the remote control and the aircraft have completed frequency linking before leaving the
factory, they can be connected directly.
3. Connection Between the Remote Control and the Drone
1.Install the drone battery; click the power button once, then quickly press it for 2s to turn on the
drone; the battery indicator will light, the drone will emit beep sound and its 4 LED foot lights start
quick flashing;
2.Press the power button of the remoter controller for 2s, then the remote controller emit 2 beep
sound and the indicator lights up;
3.Please wait about 35s, the 4 LED foot lights on the drone will stably light, which means it is done.