17
5.
Pass the cable of the power adapter
through the cable exit and then connect
it to the port on the I/O plate of your
POS system. (Please refer to
Routing
and Arranging Cables
section to thread
the cable, according to the model of
your base.)
6.
Neatly thread the cord along the bottom edge of the PoweredUSB
compartment (1), and then use the cable tie to hold the extra cable
(2) as shown in the figure.
7.
Place back the PoweredUSB
compartment bracket into place, and
then secure it using two fixing screws.
8.
Lay the POS terminal on a flat surface
with its rear facing towards you. Then,
connect the female end of power cord to
the power adapter and the other end to
the electrical outlet.
9.
To hold the power cord into place, attach the screw hole of
power cord holder to the hole at the bottom of Gen 8E base,
and then use a fixing screw to secure the power cord holder.
Cable Exit
Cable tie
(1)
(2)
