18
Installing Side Mount Upgrade Kits
Located at left side on the back of your LCD
panel, side mount compartment is mainly
used for installation of side-mounted
equipment, such as magnetic stripe reader.
For detailed installation instructions, please
refer to the user manual specific to the
device which you intend to mount onto the
terminal.
Installing Rear Top Mount Upgrade Kits
Rear top mount upgrade kits, including
customer pole displays and monitors, have to
be mounted onto the top side on the rear of
your POS terminal as shown in the figure. As
for the installation instructions along with the
individual cable arrangement for the specific
base, please be advised to read the user
manual specific to the device you intend to
install.
Installing Wall Mount Kits
The wall mount kits enable you to mount your
POS terminal onto the wall as an alternative.
Step A):
Select a flat surface on wall of
adequate strength and thickness and with
proper ventilation and space condition.
Step
B)
: To apply the plastic cotters, please drill 4
holes in rectangular layout as marked in the template that gives a rectangular
drill pattern of 6.77” or 172 mm wide (horizontal) and 3.82” or 97 mm high
(vertical). Hole diameter should be 1/4” or 6.25 mm each. Hole depth should
be at least 1 and 3/8” or 35 mm.
Step C):
Apply the 4 plastic cotters into the
drilled holes then 4 self-tapping 3.5
ψ
-16L screws through the arrowed holes
in bracket to hold it firmly on the wall.
Step D):
Hold the main unit then slide
down the winding grooves in the wall mount bracket.
Power Cord Holder
Self-tapping
