POSIFLEX DT-207 series, User Manual

Page: 9 / 20

Part 9
with the user.
When replacement of key top is required, it is advisable to use a
flattop (minus sign) screw driver (Do not use the attached key clip for this
operation.) to help getting the key top off gently. Please always first orientate
the key tops per below instructions before inserting any key top into the case
of the programmable keypad.
Failure to do so could result in permanent
damage not covered in product warranty. Please always match the latching
tab on bottom stem of key top with the tab in guiding hole and gently press the
key top down till a click sound is heard as indicated in the pictures below.
Key Identification
The keystroke type programmable keypad is provided with an easy
and durable method for reminding the user of content programmed in each
programmable key. First preprint (or write) in each cell of the attached colored
legend sheet the “name” for each key. Stick each cell to the corresponding key
top and then put on the transparent key cap from the accessories. In this way,
the labeling will be protected and resistant to scratch or rubbing. The
numerical keypad part of the keystroke type keyboard is preprinted with laser
printed keys without the transparent key cap.
When re-labeling of programmable key is required, please use the
attached key clip to hook up the transparent key cap and change the label then
re-cap.
For the flat type programmable keyboard, please print (or write) in
each cell of the attached grid legend sheet the “name” for each key and then
place in the whole sheet under the transparent film over the keyboard.
CASH DRAWER CONNECTION
The RJ11 connector in connection area of the DT system can be used
for controlling most of the common cash drawers available on the market.
However, it is most recommended that the Posiflex CR-xxx0 (the fourth digit
of the model number being “0” in each cash drawer series) be used for best
compliance.
The DT system will directly control the cash drawer using the cash
drawer port (CR) both to operate the opening mechanism and to monitor the
Single key top
Latching tab
Double key top Tab in the guide hole