POSIFLEX DT-207 series, User Manual

Page: 6 / 20

Part 6
INSTALLATION GUIDES
CAUTION: Before any installation or cable connection to the set, please
always make certain that the system is turned off and the
external power source to the set is removed to prevent electric
hazard! Never touch any metal pin in the connectors or
circuits to avoid high voltage hazard or electrostatic discharge
damage unless the operator is well grounded. Failure to do the
above will void the product warranty!
NON-USER-INSTALLABLE OPTIONS
Installation of options such as WLAN (WiFi) / RFID / MSR / HDD
must be done by a qualified technician in the dealer’s site only. This operation
is not open to end user.
OPENING CABLE COVER
The DT-207 / DT-208 series is constructed for very easy maintenance.
Press inward one at a time both plastic buttons
at lower rear corners on both sides of the
system unit (circled in right picture) to release
the lower part of cable cover. Please note that
there are 2 plastic hooks on top edge of cable
cover as rectangular marked in the picture
holding the top cover at arrowed positions.
Push down the hooks to release the cable cover
hook from the system top cover to show the
connection area.
INSTALLING UPS BATTERY (OPTION)
The UPS battery is in the carton at delivery if ordered. Push the 2
UPS battery cover latches on parting line
between the system top cover and the cable
cover to the front as arrowed in the right
picture to remove the UPS battery cover with
the customer display cover installed on it and
to reveal the UPS battery cavity. Pass the UPS
battery cable through a hole in the cavity to enter
the connection area as arrowed in the left picture.
Please note that there is a ribbon in this cavity for
easy battery retrieval. Seat the battery on this
ribbon while the free end of the ribbon comes out
as circled in the left picture.